Hyundai Elantra AD: Troubleshooting - Body (Interior and Exterior) - Hyundai Elantra AD 2017-2020 Service ManualHyundai Elantra AD: Troubleshooting

Troubleshooting

Symptom
Passible Cause
Remedy (Refer to page)
Water leaks from panorama sunroof
Deteriorated roof lid weatherstrip
Replace
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
Adjust
Wind noise around sunroof
Loose or deformed deflector, gaps in body work
Retighten adjust or replace
Noise created by moving sunroof lid
Foreign particles lodged in guide rail
Check drive cable and guide rails for foreign particles
Loose guide rails and lid
Retighten
Motor runs but sunroof does not move or moves only partially
Foreign particles lodged in guide rail
Adjust or replace
Incorrect engagement of motor pinion with drive cable
Decrease in motor`s clutch slipping force
Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due tomal adjustment of sunroof
Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed) is considered as normal
Incorrect engagement of motor pinion with drive cable
Check pinion installation and
Re-tighten motor
Worn out or damaged motor pinion bearing
Replace motor assembly
Worn out or deformed drive cable
Replace
Door glass fails to operate up and down
Incorrect window glass installation
Adjust position
Damaged or faulty regulator arm or regulator
Correct or replace
Door does not open or close completely
Incorrect door installation
Adjust position
Defective door check assembly
Correct or replace
Door hinge requires grease
Apply grease
Hood does not open or close completely
Striker and latch not properly aligned
Adjust
Incorrectly installed hood
Adjust
Incorrect hood bumper height
Adjust
Water leaks through windshield and rear window
Defective seal
Fill with sealant
Defective flange
Correct

Special Service Tools
Special Service Tools Tool (Number and name) Illustration Use 09880-4F000 Hog ring clip installer Hog ring clip installation ...

Body Dimensions
General Information General 1. This measurements are provided as reference for A/S, so it can not be used as specification. 2. Basically, all measurements ...