Hyundai Elantra MD/UD: Removal - Oil Pan. Repair procedures - Lubrication System - Engine Mechanical System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Removal

1.
Remove the under covers. (Refer to Engine and transaxle assembly)
2.
Drain engine oil.
3.
Remove the oil pan (A).
(1)
Unfasten the bolts.
(2)
Insert the blade of SST (09215-3C000) between the lower crankcase and the oil pan. Separate the applied sealer and remove the oil pan.
Loosen one oil pan bolt near each corner of the oil pan leaving the bolts held in by about 2 threads. Then remove all other pan bolts.
•
Insert the SST between the oil pan and the lower crankcase by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of more than 2/3 edge of the oil pan, remove it from the arrow around more than 2/3 edge of the oil pan, remove it from the lower crankcase.
•
Do not turn over the SST abruptly without tapping. It is result in damage of the SST.
•
Be careful not to damage the contact surfaces of the lower crankcase and the oil pan.
4.
Remove the oil screen (A) with the gasket (B).

Installation
1. Install the oil screen (A) with a new gasket (B). Tightening torque Bolt : 19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft) ...