| 1. |
Install the oil screen (A) with a new gasket (B).
Tightening torque
Bolt :
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)
Nuts :
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)
|
|
| 2. |
Install the oil pan.
| (1) |
Using a gasket scraper, remove all the old packing material
from the gasket surfaces.
|
| (2) |
The sealant locations on the oil pan and the lower crankcase
must be free of harmful foreign materials, oil, dust and moisture.
Spraying cleaner on the surface and wiping with a clean
duster.
|
| (3) |
After applying liquid sealant on the oil pan, assemble
it within 5 minutes after sealant was applied. Continuous bead
of sealant should be applied to prevent any path of oil leakage.
Bead width
Whole section :4.0 ~ 5.0 mm (0.16 ~ 0.20 in.)
Section A : 1.5 ~ 2.5 mm (0.06 ~ 0.10 in.)
Sealant: Threebond 1217H
|
| •
|
When applying sealant gasket, sealant
must not be protruded into the inside of oil
pan.
|
| •
|
To prevent leakage of oil, apply sealant
gasket on the inner threads of the bolt holes.
|
| •
|
If the sealant is applied to the bottom
surface of the lower crankcase, it should be
the same position as the oil pan.
|
|
|
| (4) |
Install the oil pan (A). Uniformly tighten the bolts in
several passes.
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
After assembly, wait at least 30 minutes before
filling the engine with oil.
|
|
Always use a new drain plug gasket.
|
|
|
| 3. |
Refill engine with engine oil.
|
1.
Remove the under covers. (Refer to Engine and transaxle assembly)
2.
Drain engine oil.
3.
Remove the oil pan (A).
...
Inspection
1.
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
...
Hyundai Elantra MD/UD: Installation
Removal
Oil Pressure Switch. Repair procedures