Hyundai Elantra HD: Power Door Lock Actuators. Repair procedures - Power Door Locks - Body Electrical System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Power Door Lock Actuators. Repair procedures

Inspection

Front Door Lock Actuator
1.
Remove the front door trim. (Refer to the Body group - Front door)
2.
Remove the front door module. (Refer to the Body group - Front door).
3.
Disconnect the connectors from the actuator.
4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Rear Door Lock Actuator
1.
Remove the rear door trim panel. (Refer to the Body group - Rear door)
2.
Remove the rear door module. (Refer to the Body group - Rear door)
3.
Disconnect the connectors from the actuator.
4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Trunk Lid Actuator
1.
Remove the trunk trim. (Refer to the Body group - Tailgate)
2.
Disconnect the 3P connector from the actuator.
3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Front Door Lock Switch
1.
Remove the front door trim. (Refer to the Body group - Front door)
2.
Remove the front door module. (Refer to the Body group - Front door).
3.
Disconnect the connectors from the actuator.
4.
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.
Rear Door Lock Switch
1.
Remove the rear door trim panel. (Refer to the Body group - Rear door)
2.
Remove the rear door module. (Refer to the Body group - Rear door)
3.
Disconnect the connectors from the actuator.
4.
Check for continuity between the terminals in each switch position according to the table.
Trunk Lid Open Switch
1.
Remove the trunk trim. (Refer to the Body group - Tailgate)
2.
Disconnect the 3P connector from the actuator.
3.
Check for continuity between the terminals in each switch position according to the table.

Components and Components Location
Component Location 1. ICM relay box (Door lock/unlock relay) 2. Body control module (BCM) 3. Front door lock actuator & switch 4. Rear door lock actuator & switch ...

Power Door Lock Relay. Repair procedures
Inspection Door Lock 1. Disconnect the negative (-) battery terminal. 2. Remove the ICM relay box. 3. Chec ...