Hyundai Elantra HD: Driver Airbag (DAB) Module and Clock Spring. Repair procedures
Removal
| 1. |
Disconnect the battery negative cable and wait at
least three minutes before beginning work.
|
| 2. |
Remove the three airbag module mounting bolts (2EA).
|
| 3. |
Release the connector locking pin(A), then disconnect
the driver airbag module connector(B).
[Depowered]
[Advanced]
|
| 4. |
Remove the steering wheel and steering wheel column
cover(Refer to ST group).
|
| 5. |
Disconnect the clock spring and steering remocon
switch connector, then remove the clock spring.
|
Installation
| 1. |
Remove ignition key from the vehicle.
|
| 2. |
Disconnect the negative (-) cable from battery and
wait for at least three minutes.
|
| 3. |
Connect the clock spring harness connetor and steering
remocon switch harness connector to the clock spring.
|
| 4. |
Set the center position by getting marks between
the clock spring and the cover into line. Make an array the mark (▶
◀) by turning the clock spring clockwise to the stop and then 3 revolutions
counterclockwise.
|
| 5. |
Install the steering wheel column cover and the steering
wheel. (Refer to ST group)
|
| 6. |
Connect the Driver Airbag (DAB) module connector
and horn connector, then install the Driver Airbag (DAB) module on the
steering wheel.
|
| 7. |
Secure the Driver Airbag (DAB) with the new mounting
bolts.
|
| 8. |
Connect the battery negative cable.
|
| 9. |
After installing the airbag, confirm proper system
operation:
|
Inspection
Driver Airbag(DAB)
If any improper parts are found during the following inspection,
replace the airbag module with a new one.
Never attempt to measure the circuit resistance of
the airbag module (squib) even if you are using the specified tester.
If the circuit resistance is measured with a tester, accidental airbag
deployment will result in serious personal injury.
|
| 1. |
Check pad cover for dents, cracks or deformities.
|
| 2. |
Check the airbag module for denting, cracking or
deformation.
|
| 3. |
Check hooks and connectors for damage, terminals
for deformities, and harness for binds.
|
| 4. |
Check airbag inflator case for dents, cracks or deformities.
[Depowered]
[Advanced]
|
| 5. |
Install the airbag module to the steering wheel to
check for fit or alignment with the wheel.
|
Clock spring
| 1. |
If, as a result of the following checks, even one
abnormal point is discovered, replace the clock spring with a new one.
|
| 2. |
Check connectors and protective tube for damage,
and terminals for deformities.
|
