Hyundai Elantra AD: Body Side Molding - Body (Interior and Exterior) - Hyundai Elantra AD 2017-2020 Service ManualHyundai Elantra AD: Body Side Molding

Delta Garnish Repair procedures

Replacement
  
• Put on gloves to prevent hand injuries.
  
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Take care not to scratch the body surface.
1. Using a screwdriver or remover, remove the delta garnish (A).
2. To intall, reverse the removal procedure.
  
• Replace any damaged clips (or pin-type retainers).

Front Wheel Guard Repair procedures

Replacement
  
• Put on gloves to prevent hand injuries.
  
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Take care not to scratch the body surface.
1. Remove the engine room cover.

(Refer to Engine Mechanical System - " Engine Room Cover")
2. Remove the front tire.
3. After loosening the mounting clips and remove the front wheel guard (A).
4. To intall, reverse the removal procedure.
  
• Replace any damaged clips (or pin-type retainers).

Rear Wheel Guard Repair procedures

Replacement
  
• Put on gloves to prevent hand injuries.
  
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Take care not to scratch the body surface.
1. Remove the rear tire.
2. After loosening the mounting screws, clips and nut, remove the rear wheel guard (A).
3. To intall, reverse the removal procedure.
  
• Replace any damaged clips (or pin-type retainers).

Front Mud Guard Repair procedures

Replacement
  
• Put on gloves to prevent hand injuries.
  
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Take care not to scratch the body surface.
1. After loosening the mounting screws and remove the front mud guard (A).
2. To intall, reverse the removal procedure.
  
• Replace any damaged clips (or pin-type retainers).

Rear Mud Guard Repair procedures

Replacement
  
• Put on gloves to prevent hand injuries.
  
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
• Take care not to scratch the body surface.
1. After loosening the mounting screws and remove the rear mud guard (A).
2. To intall, reverse the removal procedure.
  
• Replace any damaged clips (or pin-type retainers).

Roof Side Molding Repair procedures

Replacement
  
• Put on gloves to prevent hand injuries.
  
• When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
1. Using a screwdriver or remover, remove the roof side molding (A).
  
• Always replace the roof side molding to a new one.

2. To intall, reverse the removal procedure.
  
• Replace any damaged clips (or pin-type retainers).
Rear Door
Components and Components Location Components 1. Rear door trim 2. Rear door belt inside weatherstrip 3. Rear door module 4. Rear door panel 5. Rear door ...

Sunroof
Components and Components Location Components 1. Glass panel assembly 2. Deflector 3. Motor assembly 4. Spring base assembly 5. Plate rail assembly 6. Guide ...