Hyundai Elantra MD/UD: Sub Frame. Repair procedures - Front Suspension System - Suspension System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Sub Frame. Repair procedures

Replacement

1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Disconnect the stabilizer link (A) with the front strut assembly after loosening the nut.
Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

3.
Loosen the nut and then remove the tie-rod end (A) with the front axle.
Tightening torque :
23.5 ~ 33.3N.m(2.5 ~ 3.4kgf.m, 19.4 ~ 24.6lb-ft)

4.
Loosen the nut and then remove the lower arm (A).
Tightening torque :
78.5 ~ 88.3N.m(8.0 ~ 9.0kgf.m, 57.9 ~ 65.1lb-ft)

5.
Loosen the bolt and then disconnect the universal joint assembly (A) from the pinion of the steering gear box.
Tightening torque :
32.4 ~ 37.3N.m(3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb-ft)

Lock the steering wheel in the straight ahead position to prevent the damage of the clock spring inner cable when you handle the steering wheel.
6.
Remove the rubber hanger (A).
7.
Remove the cross member from the body by loosening the roll rod (A) mounting bolts and nuts.
Tightening torque :
107.9 ~ 127.5N.m(11.0 ~ 13.0kgf.m, 79.6 ~ 94.0lb-ft)

8.
Loosen the bolts & nuts and then remove the front sub frame (A).
Tightening torque :
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)

9.
Remove the lower arm.
10.
Remove the stabilizer bar.
11.
Remove the steering gear box.
(Refer to ST group - "Steering Gear Box")
12.
Installation is the reverse of removal.
13.
Check the alignment.
(Refer to 'Tires/Wheels - alingment')

Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check th ...