Removal
|
1. |
Remove the battery terminal.
|
|
3. |
Remove the under cover.
|
|
4. |
Loosen the drain plug and drain the transaxle oil.
|
|
5. |
Remove the oil pan. (Refer to Automatic transaxle's disassembly
in 'A4CF2' overhaul manual)
|
|
6. |
Remove the oil filter.
|
|
7. |
Remove the valve body. (Refer to Valve body's disassembly in 'A4CF2'
overhaul manual)
|
|
8. |
Disconnect the main harness(A) from valve body.
|
|
9. |
Remove the solenoid valve assembly(A).
|
Installation
|
1. |
Install the solenoid valve.
|
Apply the ATF oil or White Vaseline to the O-ring not
to be damaged.
|
|
|
2. |
Connect the solenoid valve connector to the valve body.
|
When connecting the solenoid valve connector, check the
connector for rust, dirt, or oil, then reconnect it.
|
|
|
3. |
Install the valve body. (Refer to Valve body's reassembly in 'A4CF2'
overhaul manual)
Tightening torque :
10~12Nm(1.0~1.2kgf.m, 7~8lb-ft)
|
|
|
4. |
Install the oil filter.
Tightening torque :
10~12Nm(1.0~1.2kgf.m, 7~8lb-ft)
|
|
|
5. |
Continue to apply liquid gasket at application points at the oil
pan with Ø2.5mm (0.098in) thickness.
Liquid gasket Part name :
Threebond 1281B
|
|
|
6. |
Tighten the mounting bolt with the specified torque after installing
the oil pan.
Tightening torque :
10~12Nm(1.0~1.2kgf.m, 7~8lb-ft)
|
|
|
7. |
Install the drain plug.
Tightening torque :
35~45Nm(3.5~4.5kgf.m, 25~32lb-ft)
|
|
|
8. |
Installation is the reverse of the removal.
|
Description
TCM calculates the best condition using the information from all kinds
of sensors. If the solenoid valve receives the information on the oil pressure,
the solenoid valve actuates ...
Description
VFS valve controls the regulator valve and varies the line pressure from
4.5bar to 10.5bar according to the throttle open angle and the shift range.
The holder is installed on th ...
Hyundai Elantra HD: Solenoid valve. Repair procedures (A4CF2)
