Removal
| •
|
Removal of the airbag must be performed according
to the precautions/procedures described previously.
|
| •
|
Before disconnecting the side impact sensor
connector(s), disconnect the side airbag connector(s).
|
| •
|
Do not turn the ignition switch ON and do
not connect the battery cable while replacing the side impact
sensor.
|
|
|
1. |
Disconnect the battery negative cable, and wait for
at least three minutes before beginning work.
|
|
2. |
Remove the following parts. (Refer to BD group)
| A. |
Center pillar trim, Door scuff trim
|
|
|
3. |
Disconnect the Side Impact Sensor connector.
|
|
4. |
Remove the SIS mounting bolt then remove the Side
Impact Sensor.
|
Installation
| •
|
Do not turn the ignition switch ON and do
not connect the battery cable while replacing the side impact
sensor.
|
|
|
1. |
Install the new Side Impact Sensor with the bolt
then connect the SRS harness connector to the Side Impact Sensor.
Tightening torque
0.7 ~ 0.8 kgf.m (6.8 ~ 7.9 Nm, 5.0 ~ 5.8
lb.ft)
|
|
|
2. |
Install the following parts. (Refer to BD group)
| A. |
Door scuff trim, Center pillar trim
|
|
|
3. |
Reconnect the negative battery cable.
|
|
4. |
After installing the Side Impact Sensor, confirm
proper system operation: Turn the ignition switch ON, the SRS indicator
light should be turned on for about six seconds and then go off.
|
Description
The STPS operates via a non-contacting magnetic proximity
sensing device combined with a simple electronic circuit resulting in the ability
of producing two separate and distinct ...
Hyundai Elantra HD: Side Impact Sensor (SIS). Repair procedures
