Removal
|
1. |
Disconnect the battery negative cable and wait at
least 3 minutes before beginning work.
|
|
2. |
Remove the front seat assambly.(Refer to BD group)
|
|
3. |
Remove the seat-back cover.(Refer to BD group)
|
|
4. |
Loosen the SAB mounting nuts and remove the SAB module.
|
The removed airbag module should be stored
in a clean, dry place with the pad cover face up.
|
|
Installation
|
Be sure to install the harness wires not to be pinched
or interfered with other parts.
|
| •
|
Do not open the lid of the side airbag cover.
|
| •
|
Use a new mounting nuts when you replace
a side airbag.
|
| •
|
Make sure that the seat-back cover is installed
properly. Improper installation may prevent the proper deployment.
|
|
|
1. |
Remove ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for
at least three minutes.
|
|
3. |
Place a Side Airbag (SAB) on the seat-back frame
and tighten the side airbag mounting nuts.
Tightening torque
: 1.1 ~ 1.5 kgf.m (10.8 ~ 14.7 Nm, 7.9 ~
10.8 lb.ft)
|
|
|
4. |
Install the new seat-back cover.(Refer to BD group)
|
|
5. |
Install the seat assembly, then connect the Side
Airbag (SAB) harness connector.
|
|
6. |
Recline and slide the front seat forward fully, make
sure the harness wires are not pinched or interfering with other parts.
|
|
7. |
Reconnect the battery negative cable.
|
|
8. |
After installing the Side Airbag (SAB), confirm proper
system operation:
| A. |
Turn the ignition switch ON; the SRS indicator
light should be turned on for about six seconds and then go
off.
|
|
Description
Curtain airbags are installed inside the headliner (LH and
RH) and protect the driver and passanger from danger when side crash occurs.
The SRSCM determines deployment of curtain ...
Hyundai Elantra HD: Side Airbag (SAB) Module. Repair procedures
