Hyundai Elantra HD: Seat Track Position Sensor (STPS). Repair procedures - SRSCM - Restraint - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Seat Track Position Sensor (STPS). Repair procedures

Fourth generation (HD; 2007–2010) / Hyundai Elantra HD 2006–2010 Service Manual / Restraint / SRSCM / Seat Track Position Sensor (STPS). Repair procedures

Removal

1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly. (Refer to BD group)
3.
Loosen the two STPS screws, then remove the STPS after disconnecting the STPS connector.

Installation

Ensure that the harness is installed and routed properly to prevent damage to the wiring.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the ignition key from the vehicle.
3.
Install the STPS with two screws.
4.
Install the front seat assembly. (Refer to BD group)
5.
Reconnect the battery negative cable.
6.
After installing the Seat Track Position Sensor, confirm proper system operation:
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...