Hyundai Elantra MD/UD: Removal - Parking Brake Assembly. Repair procedures - Parking Brake System - Brake System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Removal

Rear Disc Brake Type
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console.
(Refer to Body group.-"Floor console")
2.
Disconnect the connector (A) of parking brake switch.

3.
Remove the cable retainer (A).

4.
Loosen the adjusting nut (A) and the parking brake cables.

Parking brake lever in the car must be in fully loosened position.
5.
Remove the parking brake lever assembly (A) after removing the bolts.

6.
Raise the vehicle, and make sure it is securely supported.
7.
Remove the rear tire and wheel.
8.
Remove the parking brake cable (B), after removing the clip (A).

9.
Loosen the parking brake cable bracket bolts and remove the parking brake cable (A).

Rear Drum Brake Type
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console.
(Refer to Body group.-"Floor console")
2.
Disconnect the connector (A) of parking brake switch.

3.
Remove the cable retainer (A).

4.
Loosen the adjusting nut (A) and the parking brake cables.

Parking brake lever in the car must be in fully loosened position.
5.
Remove the parking brake lever assembly (A) after removing the bolts.

6.
Raise the vehicle, and make sure it is securely supported.
7.
Remove the rear tire and wheel.
8.
Remove the parking brake cable from the brake shoe. (Refer to the rear drum brake)
9.
Remove the parking brake cable (B), after removing the clip (A).

10.
Loosen the parking brake cable bracket bolts and remove the parking brake cable (A).


Installation
Rear Disc Brake Type 1. Install the parking brake cable (A). 2. Install the parking brake cable (B), and then install the ...