Hyundai Elantra MD/UD: Removal - Automatic Transaxle. Repair procedures - Automatic Transaxle System - Automatic Transaxle System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Removal

1.
Remove the following items;
A.
Engine cover.
B.
Air cleaner assembly and air duct. (Refer to "Intake and Exhaust system" in EM group.)
C.
Battery and battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the ground line after removing the bolt (A).
3.
Dissconnect the solenoid valve connector (A) and inhibitor switch connector (B).
4.
Remove the control cable (C) after removing the nut (A) and the bolt (B).
Tightening torque:
(A) 9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)
(B) 14.7 ~ 21.6 N.m(1.5 ~ 2.2 kgf.m, 10.9 ~ 15.9 lb-ft)

5.
Disconnect the hose (B) after removing the automatic transaxle fluid cooler hose clamp (A).

6.
Remove thd wiring clips (A).
7.
Remove the solenoid valve connector and inhibitor switch connector wiring mounting bracket (A).
8.
Using the engine support fixture (SST No.: 09200-38001), hold the engine and transaxle assembly safely.

9.
Remove the automatic transaxle upper mounting bolt (A-2ea) and the starter motor mounting bolt (B-2ea).
Tightening torque:
(A,B) 42.2 ~ 54.0 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)

10.
Remove the automatic transaxle mounting support bracket bolt (A).
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.8 lb-ft)

11.
Lift the vehicle with a jack.
12.
Remove the under cover (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

13.
Remove the roll stopper (C) after removing the bolt (A) and (B).
14.
Remove the following items.
A.
Drive shaft assembly.
(Refer to "Drive shaft assembly " in DS group.)
15.
Remove the dust cover (A).
16.
Remove the torque converter mounting bolt (A-4ea) with rotating the crankshaft.
Tightening torque:
45.1 ~ 52.0 N.m (4.6 ~ 5.3 kgf.m, 33.3 ~ 38.3 lb-ft)

17.
Remove the automatic transaxle with a jack after removing the mounting bolt (A-2ea, B-3ea).
Tightening torque:
(A) 42.2 ~ 53.9 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
(B) 39.2 ~ 46.1 N.m (4.0 ~ 4.7 kgf.m, 28.9 ~ 34.0 lb-ft)


Installation
1. Installation is the reverse of removal. If the oil seal on the transaxle case side is damaged a ...