|
1. |
Installation is the reverse of removal.
|
Use a new washer (A) whenever installing.
|
|
When installing the RH rear brake hose, the brake tube
must not be touched to the tire.
| 1. |
Without the brake tube fixing clip
|
|
- |
When tightening the brake tube flare nut (A),
tighten it with a specified torque by pushing it toward
the car body not to damage to the brake tube (B).
Tightening torque :
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4
~ 12.3 lb-ft)
|
|
|
- |
After installation, check that the brake tube
must not be touched to the tire.
|
| 2. |
With the brake tube fixing clip
|
|
- |
Insert the brake fixing clip (B) to the end after
fixing the brake tube to the brake tube fixing clip
(B).
|
|
- |
Tighten the brake tube flare nut (A) with a specified
torque.
Tightening torque :
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4
~ 12.3 lb-ft)
|
|
|
- |
Check again that the brake tube fixing clip (B)
must be fixed in place.
|
|
|
|
2. |
After installation, bleed the brake system.
(Refer to Brake system bleeding)
|
|
3. |
Check the spilled brake oil.
|
1.
Check the brake tubes for cracks, crimps and corrosion.
2.
Check the brake hoses for cracks, damage and fluid leakage.
3 ...
Components
1. Cowl bracket
2. Brake pedal member assembly
3. Stop lamp switch
4. Return spring
5. Brake pedal
...
Hyundai Elantra MD/UD: Installation
