|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
|
3. |
Tighten the curtain airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
• |
Never twist the airbag module during installation.
If the airbag module is twisted, it may not operate
as designed.
|
|
|
|
4. |
Connect the curtain airbag connector.
|
|
5. |
Install the roof trim.
(Refer to the Body group- "Interior")
|
|
6. |
Reconnect the battery negative cable.
|
|
7. |
After installing the curtain airbag (CAB), confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
1.
Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
2.
Remove the roof trim.
(Refer to ...
Airbag Disposal
Special tool required
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those installed
in vehicle to be scrapped), the airb ...
Hyundai Elantra MD/UD: Installation
