|
Be sure to install the harness wires so they will not pinch or
interfere with other parts.
|
| •
|
Do not open the lid of the side airbag cover.
|
| •
|
Make sure that the airbag assembly cover is installed
properly. Improper installation may prevent the proper deployment.
|
|
|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
|
3. |
Install the new seat back assembly.
(Refer to the Body group - "Seat")
|
|
4. |
Install the front seat assembly.
(Refer to the Body group - "Seat")
|
|
5. |
Recline and slide the front seat forward fully, make sure the
harness wires are not pinched of interfere with other parts.
|
|
6. |
Reconnect the battery negative cable.
|
|
7. |
After installing the side airbag (SAB), confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
The side airbag cannot be disassembled from the seat back assembly,
so replace the seat back assembly when replacing the side a ...
Description
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain ...
Hyundai Elantra MD/UD: Installation
