Hyundai Elantra MD/UD: Installation - Seat Track Position Sensor (STPS). Repair procedures - SRSCM - Restraint - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the STPS with two screws.
4.
Install the front seat assembly. (Refer to BD group)
5.
Reconnect the battery negative cable.
6.
After installing the Seat Track Position Sensor, confirm proper system operation:
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.

Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Re ...

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status ...