| •
|
Do not turn the ignition switch ON and do not contact
the battery cable while replacing the front impact sensor.
|
|
|
1. |
Install the new front impact sensor.
|
|
2. |
Tighten the front impact sensor mounting nut.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
|
|
|
3. |
Connect the front impact sensor connector.
|
|
4. |
Install the head lamp assembly (A).
(Refer to the Body Electrical group - "Head lamps")
|
|
5. |
Reconnect the battery negative cable.
|
|
6. |
After installing the Front Impact Sensor, confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
•
Removal of the airbag must be performed according to the
precautions/ procedures described ...
Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pilla ...
Hyundai Elantra MD/UD: Installation
