|
1. |
Remove the ignition key from the vehicle.
|
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
|
3. |
Install the SRSCM with the SRSCM mounting bolts.
Tightening torque
9.8 ~ 13.7 N.m (0.8 ~ 1.0 kgf.m, 7.2 ~ 10.1 lb-ft)
|
|
Use new mounting bolts when replacing the SRSCM after
a collision.
When installing the SRSCM bolt, install the ground wire
(B) with a bolt as indicated above picture.
|
|
|
4. |
Connect the SRSCM harness connector.
|
|
5. |
Install the rear heating joint duct and floor console. (Refer
to the Body group - "Console")
|
|
6. |
Reconnect the battery negative cable.
|
|
7. |
After installing the SRSCM, confirm proper system operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
O ...
Hyundai Elantra MD/UD: Installation
