|
If reinstalling used cover, the cover should be installed with
its clutch disc as a set.
|
|
1. |
Apply grease on a disc spline part and transmission input shaft
spline part as required.
|
* Possible problems when not following
|
- |
When not applying: Excessive wear of splines and
bad clutch operation can occur.
|
|
- |
When excessively applying: Grease can be scattered
bycentrifugal force which can conteminate the clutch
disc. This can cause a loss of friction force causing
a slip.
|
|
|
|
2. |
The 'T/M SIDE' marked surface should face the engineer.
|
* Possible problems when the disc is installed in the
opposite direction.
|
• |
Transaxle shift errror or a strangesound can occur
due to clutch separation.
|
|
|
|
3. |
Install the clutch disc and the cover with SST (A: 09411-1P000).
|
|
4. |
Install the clutch cover bolts. Not to be bent or twisted, Tighten
them in diagonal directions.
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)
|
|
• |
Loosely tighten every clutch cover bolts, then
torque to specifications in a diagonal direction. This
can prevent twisting, vibration of the cover, and the
lifting of the pressure plate.
|
|
• |
Install the all the components with the specified
torques. If not, the clutch torque transmission may
have concerns or the mounting bolt can loosen.
|
|
|
|
5. |
Install the transaxle assembly.
(Refer to "Manual transaxle system" in MT group.)
|
1.
Inspect diaphragm spring wear which is in contact with a concentric
slave cylinder bearing.
2.
Check the clutch cover and disc surface f ...
Components
1. Reverse hose
2. Master cylinder
3. Ignition lock switch
4. Clutch switch
5. Clutch arm assembly
6. Pedal pad
...
Hyundai Elantra MD/UD: Installation
