Installation is in the reverse order of removal.
|
Perform the following:
| • |
Refill engine with engine oil.
|
| • |
Refill a transaxle with fluid.
|
| • |
Refill a radiator and a reservoir tank with engine coolant.
|
| • |
Clean battery posts and cable terminals and assemble.
|
| • |
Inspect for fuel leakage.
|
| - |
After assembling the fuel line, turn on the ignition switch
(do not operate the starter) so that the fuel pump runs for
approximately two seconds and fuel line pressurizes.
|
| - |
Repeat this operation two or three times, then check for
fuel leakage at any point in the fuel line.
|
| • |
Bleed air from the cooling system.
|
| - |
Start engine and let it run until it warms up (until the
radiator fan operates 3 or 4 times).
|
| - |
Turn off the engine. Check the level in the radiator,
add coolant if needed. This will allow trapped air to be removed
from the cooling system.
|
| - |
Put radiator cap on tightly, then run the engine again
and check for leaks.
|
|
•
Use fender covers to avoid damaging painted surfaces.
•
...
Hyundai Elantra MD/UD: Installation
Removal
Timing System