Hyundai Elantra HD: Immobilizer Control Unit. Repair procedures - Immobilizer System - Body Electrical System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Immobilizer Control Unit. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad. (Refer to the Body group - "Crash pad").
3.
Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) and bracket (B)after loosening a shear bolt (C).
-
Punch the shear bolt using a centering punch.
-
And drill its head off with a drill bit.
-
Becarefull not to damage the SMARTRA unit.


Installation

1.
Install the immobilizer control unit and bracket after connecting the unit connector.
-
Tighten the shear bolt until the bolt head break off.
2.
Install the crash pad.

Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner ...

Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering clumn upper and lower shrouds (A). (Refer to the ST group ...