Hyundai Elantra HD: Front Washer Motor. Repair procedures

Removal

-	When servicing the washer pump, be careful not to damage the washer pump seal.

-	Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body group - Front bumper)

3.	Remove the washer hose and the washer motor connector (A).

4.	Remove the washer reservoir (A) after removing 2 bolts.

Installation

Install the washer reservoir.

Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.

2.	Install the washer motor and connect the washer hose and the motor connector.

3.	Install the front bumper cover.

Inspection

With the washer motor connected to the reservoir tank, fill the reservoir tank with water.

Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.

2.	Connect positive (+) battery cables to terminal 2 and negative (-) battery cables to terminal 1 respectively.

3.	Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.

4.	If they are abnormal, replace the washer motor (A).

Washer Fluid Level Sensor Switch

1.	Disconnect the negative(-) battery terminal.

2.	Drain the washer fluid less than 800 cc (28 fl.oz.).

3.	Check for continuity between the No. 1 and No.2 terminal in each float position. There should be continuity when the float is down. There should be no continuity when the float is up.

4.	If the continuity is not as specified, replace the washer fluid level switch(A).

Removal 1. Remove the windshield wiper arm and blade after removing a nut (A). 2. Remove the weather strip and the cowl top cover ...

Troubleshooting 1. Wiper low and wiper high do not work. 2. When washer switch is on, wiper does not work. ...