Removal
| •
|
Removal of the airbag must be performed according
to the precautions/ procedures described previously.
|
| •
|
Before disconnecting the front impact sensor
connector, disconnect the front airbag connector(s).
|
| •
|
Do not turn the ignition switch ON and do
not connect the battery cable while replacing the front impact
sensor.
|
|
|
1. |
Disconnect the battery negative cable, and wait for
at least three minutes before beginning work.
|
|
2. |
Remove the under cover, then loosen the FIS mounting
bolt to remove Front Impact Sensor.(LH)
|
|
3. |
Remove the FIS mounting bolt then remove the Front
Impact Sensor(RH).
|
|
4. |
Disconnect the Front Impact Sensor connector.
|
Installation
| •
|
Do not turn the ignition switch ON and do
not contact the battery cable while replacing the front impact
sensor.
|
|
|
1. |
Install the new Front Impact Sensor with bolt then
connect the SRS harness connector to the Front Impact Sensor.
Tightening torque
: 0.7 ~ 0.8 kgf.m (6.8 ~ 7.9 Nm, 5.0 ~ 5.8
lb.ft)
|
|
|
2. |
Install the under cover.(LH)
|
|
3. |
Reconnect the negative battery cable.
|
|
4. |
After installing the Front Impact Sensor, confirm
proper system operation: Turn the ignition switch ON the SRS indicator
light should be turned on for about six seconds and then go off.
|
Description
The Side Impact Sensor (SIS) system consists of two front
SIS which are installed inside the Center Pillar (LH and RH).
They are remote sensors that detect acceleration due to ...
Hyundai Elantra HD: Front Impact Sensor (FIS). Repair procedures
