Hyundai Elantra MD/UD: Emission Control System > Evaporative Emission Control System > Repair procedures - Emission Control System - Hyundai Elantra MD 2010-2015 Service manualHyundai Elantra MD/UD: Emission Control System > Evaporative Emission Control System > Repair procedures

Fifth generation (MD/UD; 2011–2016) / Hyundai Elantra MD 2010-2015 Service manual / Emission Control System / Emission Control System > Evaporative Emission Control System > Repair procedures

Inspection

[System Inspection]
1.
Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]
Engine
Operating
Condition
 Applied
Vacuum
 Result
Idle
 Min. 20 inHg
(Min. 0.7 kgf/cm², Min. 67.7 kPa)
 Vacuum is held
3,000rpm

2.
Check the following points with applied vacuum at the purge control solenoid valve (PCSV).
· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]
Engine
Operating
Condition
 Applied
Vacuum
 Result
Idle
 Min. 20 inHg
(Min. 0.7 kgf/cm², Min. 67.7 kPa)
 Vacuum is held
Within 3 minutes after engine start at 3,000 rpm
 Try to apply vacuum
 Vacuum is released
In 3 minutes after engine start at 3,000 rpm
 Min. 20 inHg
(Min. 0.7 kgf/cm², Min. 67.7 kPa)
 Vacuum will be held momentarily, after which, it will be released

[PCSV Inspection]
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the PCSV connector (A).
3.
Disconnect the vapor hose (B) which is connected to the intake manifold from the PCSV.
4.
After connecting a vacuum pump to the nipple, apply vacuum.
5.
With the PCSV control line grounded, check the valve operation with battery voltage applied to the PCSV(Open) and removed(Closed).
Battery Voltage
 Valve
 Vacuum
Connected
 Open
 Released
Disconnected
 Close
 Maintained

6.
Measure the coil resistance of the PCSV.
Specifications:
22.0 ~ 26.0Ω [20°C(68°F)]
[EVAP. Leakage Test]
1.
Select "Evap. Leakage Test".
2.
Proceed with the test according to the screen introductions.

Emission Control System > Evaporative Emission Control System > Schematic Diagrams
Schematic Diagram Canister The Canister is filled with charcoal and absorbs evaporated fuel vapor from the fuel tank. The gathered fuel vapor in canister is drawn into the intake ma ...

Emission Control System > Evaporative Emission Control System > Canister > Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the canister close valve connector (A ...