|
1. |
Make sure the ignition switch and all accessories are in the OFF
position.
|
|
2. |
Disconnect the battery cables (negative first).
|
|
3. |
Remove the battery from the vehicle.
|
• |
Care should be taken in the event the battery
case is cracked or leaking, to protect your skin from
the electrolyte.
Heavy rubber gloves (not the household type) should
be wore when removing the battery.
|
|
|
|
4. |
Inspect the battery tray for damage caused by the loss of electrolyte.
If acid damage is present, it will be necessary to clean the area with
a solution of clean warm water and baking soda. Scrub the area with
a stiff brush and wipe off with a cloth moistened with baking soda and
water.
|
|
5. |
Clean the top of the battery with the same solution as described
above.
|
|
6. |
Inspect the battery case and cover for cracks. If cracks are present,
the battery must be replaced.
|
|
7. |
Clean the battery posts with a suitable battery post tool.
|
|
8. |
Clean the inside surface of the terminal clamps with a suitable
battery cleaning tool. Replace damaged or frayed cables and broken terminal
clamps.
|
|
9. |
Install the battery in the vehicle.
|
|
10. |
Connect the cable terminals to the battery post, making sure tops
of the terminals are flush with the tops of the posts .
|
|
11. |
Tighten the terminal nuts securely.
|
|
12. |
Coat all connections with light mineral grease after tightening.
|
• |
When batteries are being charged, an explosive
gas forms beneath the cover of each cell. Do not smoke
near batteries being charged or which have recently
been charged. Do not break live circuit at the terminals
of batteries being charged.
A spark will occur when the circuit is broken.
Keep open flames away from battery.
|
|
|
1.
Turn the all electric devices OFF, and then turn the ignition
switch OFF.
2.
Close all doors except the engine hood, and then lock all d ...
Hyundai Elantra MD/UD: Cleaning
