Hyundai Elantra HD: Brake Booster. Repair procedures
Removal
| 1. |
Disconnect the vacuum hose (B) from the brake booster (A).
|
| 2. |
Remove the master cylinder.
(Refer to Master cylinder - Removal")
|
| 3. |
Remove the clevis pin (A) and snap pin (B).
|
| 4. |
Remove the four booster mounting nuts (C).
|
| 5. |
Remove the brake booster (A) from the engine compartment.
|
Installation
| 1. |
Adjust push rod length of the booster, and then install the seal
on the booster assembly.
|
| 2. |
Insert the booster and tighten the nuts (C).
|
| 3. |
Connect the booster push rod and brake pedal with a clevis pin
(A) and install a snap pin (B) to the clevis pin (A).
|
| 4. |
Install the master cylinder, then install the brake tubes to the
master cylinder.
|
| 5. |
Connect the vacuum hose to the brake booster.
|
| 6. |
After filling the brake reservoir with brake fluid, bleed the
system.
|
| 7. |
Check for fluid leakage.
|
| 8. |
Check and adjust the brake pedal for proper operation.
|
