Hyundai Elantra HD: Alignment. Repair procedures - Tires/Wheels - Suspension System - Hyundai Elantra HD 2006–2010 Service ManualHyundai Elantra HD: Alignment. Repair procedures

Front Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead.
Prior to inspection, make sure that the front suspension and steering system are in normal operating condition and that the tires are inflated to the specified pressure.
Toe

B - A. 0: Toe in (+)
B - A < 0: Toe out (-)
Toe Adjustment
1.
Loosen the tie rod end lock nut.
2.
Remove the bellows clip to prevent the bellows from being twisted.
3.
Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.
Toe-in :
Total : 0°±0.2°
Individual : 0°±0.1°
Tie rod
 Turning direction
 Toe
LH
(Driver's side)
 Reward
 Decrease
(Toe in)
Forward
 Increase
(Toe out)
RH
 Reward
 Increase
(Toe out)
Forward
 Decrease
(Toe in)

4.
When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.
Tightening torque :
50 ~ 55N.m (5.0 ~ 5.5kgf.m, 36 ~ 40lb-ft)
Camber and Caster
Camber and Caster are pre-set at the factory, so they do not need to be adjusted. If the camber and caster are not within the standard value, replace or repair the damaged parts and then inspect again.
Camber angle: -0.6°±0.5°
Caster angle: 4.32 ° ± 0.5°

Rear Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on a level surface.
Prior to inspection, make sure that the rear suspension system is in normal operating condition and that the tires are inflated to the specified pressure.
Toe

B - A. 0: Toe in (+)
B - A < 0: Toe out (-)
Toe Adjustment
1.
Loosen the nut holding the assist arm cam bolt (A).
2.
Adjust rear toe by turning the rear assist arm cam bolt (A) clockwise or counter clockwise. Toe adjustment should be made by turning the right and left cam bolt by the same amount.
Toe-in :
Total : 0.22°±0.2°
Individual : 0.11°±0.1°
Cam bolt
 Turning direction
 Toe
LH
(Driver's side)
 Clockwise
 Decrease
(Toe in)
Counter
clockwise
 Increase
(Toe out)
RH
 Clockwise
 Increase
(Toe out)
Counter
clockwise
 Decrease
(Toe in)

3.
When completing the toe adjustment, tighten the nut to specified torque.
Tightening torque :
100 ~ 120N.m (10.0 ~ 12.0kgf.m, 72 ~ 87lb-ft)
Camber
Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.
Camber: -1°±0.5°

Wheel. Repair procedures
Hub Nut Tightening Sequence Tighten the hub nuts as follows. Tightening torque : 90 ~ 110N.m (9.0 ~ 11.0kgf.m, 65 ~ 80lb-ft) ...