| Parking Brake Lever Stroke Adjustment |
|
1. |
Remove the floor console.
(Refer to Body group - "Floor console")
|
|
2. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
Specified grease :
Multi purpose grease SAE J310, NLGI No.2
|
|
|
3. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke :
5 ~ 7 clicks (Pull the lever with 196N (20 kgf, 44 lbf))
|
|
After repairing the parking brake shoe, adjust the brake
shoe clearance, and then adjust the parking brake lever stroke.
(Refer to "Parking brake shoe installation")
|
|
|
4. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
|
5. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
|
6. |
Install the floor console.
(Refer to the Body group - "Floor console")
|
| Parking Brake Shoe Clearance Adjustment |
Rear Drum Brake Type
|
1. |
Depress the brake pedal several times to set the self-adjusting
brake.
|
For Drum Brake type, shoe clearance is automatically adjusted
by the adjuster and adjusting lever.
|
|
Rear Disc Brake Type
|
Re-setting of the parking brake is necessary after overhauling
the caliper body, or if the brake calipers, housing, parking brake cable
or brake discs have been changed.
|
|
1. |
Remove the floor console to reach the adjusting nut.
|
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
Distance (A+D):
Max. 3 mm (0.12 in)
|
|
|
5. |
Refit the floor console.
|
|
6. |
Parking brake lever in the car must be in fully loosened position.
|
|
7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
|
8. |
Check the wheels of their free operation.
|
Rear Disc Brake Type
1.
Install the parking brake cable (A).
2.
Install the parking brake cable (B), and then install the ...
Hyundai Elantra MD/UD: Adjustment
